Continental Refrigerator Undercounter Refrigerator and Freezer Bedienungsanleitung

Operation, Installation andInstruction ManualForUndercounter Refrigerators and Freezersand Pizza Preparation TablesA Division of National Refrigeratio

FIGURE 4OPTIONALELECTRIC CONDENSATE EVAPORATOR INSTALLATIONREMOVAL OF DOORS AND DOOR ADJUSTMENTDuring installation, it may become necessary to remove

FIGURE 5DOOR ADJUSTMENT AND REMOVALSELF-CLOSING HINGE MECHANISM MOUNTINGFor proper operation of the self-closing doors on all sandwich unit and prep m

REMOVAL AND REPLACEMENT OF HINGE MECHANISMTo remove the hinge mechanism from the door, remove the door from the cabinet as explained above. As shown i

Important Note: Never use harsh detergents, cleaners, scouring powders or chemicals when cleaning your model. Failure to dry the interior surfaces aft

208-230 VOLT, 60 HZ, 1 PHASE CONNECTIONAll 208-230 volt models are to be permanently connected and are provided with four (4) field wiring leads which

OPERATIONAll cabinets must be given sufficient time to reach normal operating temperature before placing any food inside cabinet or pans (if equipped)

PIZZA PREP TEMP ADJUSTMENT - COLDWALL RAILIf an adjustment is necessary to maintain the coldwall rail temperature, a pressure control is located behin

DEFROST OPERATIONAll freezer models are equipped with an automatic, electric defrost system consistingof an electric evaporator coil heater, evaporato

FIGURE 7EVAPORATOR ASSEMBLYINTERIOR ACCESSORIESThe standard interior accessory package that is supplied from the factory with yournew sandwich unit mo

FIGURE 8STANDARD SHELF PILASTEROPTIONAL ACCESSORIESIn addition to the optional heavy-duty pilaster and clip as shown in figure 9, all models are avail

Operators ManualTable of Contents PageReceiving Your New Model ...

FIGURE 9OPTIONALHEAVY-DUTY PILASTEROPTIONAL OVERHEAD OR DOUBLE-OVERHEAD SHELFAll open top models are available with an optional overhead or double-ove

To stack your models, the following instructions should be followed:1. Decide which model is to be on “top” and which model is to be on “bottom".

SAFETY PRECAUTIONSThe following safety precautions should be followed when operating any appliances: Always disconnect the power cord before attempti

Precautions1. Never use harsh detergents, cleaners, scouring powders, or chemicals whencleaning your model.2. Strong bleaches tend to corrode many mat

MODEL # ____________________________Serial#________________Notes: ____________________________________________________________________________________

TROUBLESHOOTING AND SERVICING GUIDE25PROBLEM PROBABLE CAUSE CORRECTIONCondensing unit will 1.Line Disconnected, Switch Open. 1.Close Start Or Disconne

PROBLEM PROBABLE CAUSE CORRECTIONCondensing unit 1.Overload Protector. 1.See Problem # 3.runs, but shorts 2.Thermostat. 2.Differential Must Be Widened

PROBLEM PROBABLE CAUSE CORRECTIONProduct zone 1.Control Setting Too High. 1.Adjust T-Stat.temperature too 2.Inadequate Air Circulation. 2.Rearrange

28WIRING DIAGRAMS

29

RECEIVING YOUR NEW MODELCongratulations on your recent purchase of Continental Refrigerator superior foodequipment products! When your shipment arrive

30

Continental Warranty ProcedureOur warranty is 1 year on parts and labor, and 5 years on the compressor from date of original installation on any unit

32Warranty Compressor ProceduresIf the compressor fails within the first (12) months of use or (20) months by thedate code on the compressor, an “over

33Items NOT Covered Under WarrantyConsult your owner's manual for detailed information on the following (page #'s listed beside each line it

UNCRATING YOUR NEW MODELThe shipping container should remain on your model as protection against dents or scratches while transporting it to the actua

Important Note: To assure maximum operating efficiency, your new “SW” seriesmodel should be located where an unrestricted air supply can circulate und

FIGURE 1bMINIMUM CLEARANCE DIMENSIONS WITHOUT LEGSFLOOR LOADSThe floor at the final location site must be level, free of vibration and strong enough t

INSTALLING LEGS AND LEVELINGYour new “SW” series model is supplied with adjustable type legs for leveling purposes. Each SW27, SW48, SW60 and SW72 mod

Important Note: It is extremely important that your new model is perfectlylevel for proper operation. If it is not level, the following adverse condit

FIGURE 3CASTERS MUST BE TIGHT TO CABINET BOTTOMINSTALLING CONDENSATE EVAPORATORNo floor drains or plumbing connections are required since all models u